SIMILAR PRODUCTS
850W SGMGV-09ADA61+SGDV-7R6A01A
850W SGMGV-09ADA6C+SGDV-7R6A01A
1.3KW SGMGV-13ADA61+SGDV-120A01A
1.3KW SGMGV-13ADA6C+SGDV-120A01A
2KW SGMGV-20ADA61+SGDV-180A01A
2KW SGMGV-20ADA6C+SGDV-180A01A
3KW SGMGV-30ADA61+SGDV-200A01A
3KW SGMGV-30ADA6C+SGDV-200A01A
4.4KW SGMGV-44ADA61+SGDV-330A01A
4.4KW SGMGV-44ADA6C+SGDV-330A01A
5.5KW SGMGV-55ADA61+SGDV-470A01A
5.5KW SGMGV-55ADA6C+SGDV-470A01A
7.5KW SGMGV-75ADA61+SGDV-550A01A
7.5KW SGMGV-75ADA6C+SGDV-550A01A
11KW SGMGV-1AADA61+SGDV-590A01A
11KW SGMGV-1AADA6C+SGDV-590A01A
15KW SGMGV-1EADA61+SGDV-780A01A
15KW SGMGV-1EADA6C+SGDV-780A01A
If the motor will not be put into service immediately, certain precautions should be taken to protect the
motor while in storage. It is recommended the motor be placed under cover in a clean, dry location.
During storage, windings should be protected from excessive moisture by some safe and reliable method
of heating, such as space heaters, to keep the temperature of windings above the temperature of the
surrounding air. It is recommended the motor in storage be inspected at periodic intervals, the windings
meggered and a log kept of pertinent data. (Refer to the OPERATION section.) Any significant drop in
insulation resistance should be investigated.
Precautions are taken by the factory to guard against corrosion. The machined parts are coated to prevent
rust during shipment. If the equipment is to be stored, examine the machined parts carefully for rust and
moisture and recoat where necessary. Motors with oil-lubricated or oil-mist lubricated bearings are normally operated and tested in the factory with a rust-inhibiting oil in the lubrication system. A rust-inhibiting film remains on critical bearing surfaces during transit and for up to six months in storage. However, when the machine is received, it is recommended that the bearing oil reservoirs on sleeve bearing motors be filled to the proper oil level with a good grade of rust-inhibiting oil.
Rotate the shaft of two-bearing machines (10 to 25 revolutions) until the journals are thoroughly coated with oil.
The bearings of grease-lubricated motors are greased at the factory with the grease cavity approximately
50% full. Rotate the shaft of all grease-lubricated motors 10-20 revolutions at two-month intervals.
If the purchaser has specified the machine bepackaged for long-term storage, the foregoing
recommendations do not apply and the packing should be left intact during the period of storage.
